Comfort is a Priority

We want you to get exactly the right fit, for the most comfortable wear of our rings. Follow our easy steps to ensure the best fit of your new ring.

 

 

Option A - Using a ring that already fits

If you have a traditional ring that fits, in the perfect size for the finger of your choice, great! Get a ruler or tape measure and measure the inner diameter of your ring at the widest point (on the inside) to the nearest millimeter (mm). 

Take that number in mm and use the table below to select your Libiti Ring size.

IMPORTANT: if your current ring fits loose or too snug, we recommend Option B to ensure the best fit.

 

Option B - Measure your finger

Choose which finger you want to wear your ring on. The fingers on your dominant hand tend to be larger than your non-dominant one, so ensure you pick the finger you have in mind to wear your Libiti Ring.

Also, ensure you measure your finger when it's not too cold or too warm. Fingers tend to swell up or down depending on the weather conditions. Water retention and some medications can create swelling. Just be aware of the condition of your finger before you measure (and wait if it's looking a little swollen).

  

Cut a strip of paper and wrap it around the base of the finger you've chosen. Pull it snug against the finger. If you can, mark a straight line from one side to the other side, ensuring to wrap it as snug as you want the ring to fit. Get a friend to help if it is too challenging.

 Once you've marked the lines, lay the strip of paper flat and measure the distance between the 2 lines that you have drawn. Measure this down to the millimetre - no rounding up!

 

Finding your perfect fit

Look at the table below and discover your ring size. Select this size on your chosen Libiti Ring and voila! Perfect fit. Through body heat, our rings tend to adapt to your finger if you're measuring in between two sizes, we recommend the smaller size. We have some sneaky (but safe) ways to stretch the ring but nothing up our sleeve to shrink it. 

If you have any questions or you're unsure, just get in touch.

You can also check our our ring exchange FAQs for further details.

 

Ring Size	Diameter (mm)	Circumference (mm)
4	15.3	48.0	I
5	15.7	49.3	J ½
6	16.5	51.8	L ½
7	17.3	54.3	N ½
8	18.2	56.8	P ½
9	18.9	59.3	R ½
10	19.8	62.1	T ½
11	20.6	64.6	V ½
12	21.4	67.2	X ½
13	22.2	69.7	Z ½
14	23.0	72.2	Z+3
15	23.8	74.8	Z+4
16	24.6	77.4	Z+5

 

Option C- Printable Ring Sizer

 We have attached a pdf of a Printable Ring Sizer.

Please make sure that your printer is set to 100% print size. (If not sure about your printer setting, do the following: Go to File > Print Preview > Print Size = 100% > 

To verify that the printable ring sizer printed correctly, measure the ring sizer - it must be about 3 1/2 inches or 8.9cm). 

1. Print out this page. 
2. Cut out your Ring Sizer as shown on the diagram. 
3. Insert the sharp point marked "A" through the slot "B".
4. Place the Ring Sizer over your finger and pull the tab until it fits comfortably. 5. Read the size from the scale.

Remember, these rings have some flexibility, so unlike traditional metal rings, some snugness is still comfortable and we have ways of making it a perfect feel for the ultimate ring comfort.